What is the control design of a grid connected inverter?

The control design of this type of inverter may be challenging as several algorithms are required to run the inverter. This reference design uses the C2000 microcontroller (MCU) family of devices to implement control of a grid connected inverter with output current control.

Can a grid connected inverter be left unattended?

Do not leave the design powered when unattended. Grid connected inverters (GCI) are commonly used in applications such as photovoltaic inverters to generate a regulated AC current to feed into the grid. The control design of this type of inverter may be challenging as several algorithms are required to run the inverter.

What should a user not do when using a grid connected inverter?

The user must not touch the board at any point during operation or immediately after operating, as high temperatures may be present. Do not leave the design powered when unattended. Grid connected inverters (GCI) are commonly used in applications such as photovoltaic inverters to generate a regulated AC current to feed into the grid.

How do I know if a grid connected inverter is working?

Observe the current that is shared on the load by the inverter, and the AC source. Spiking around the zero crossing can occur. These spikes may be mitigated by the user by selecting a different inverter configuration, or using a different modulation scheme. The verification of the grid connected mode of operation is complete.

What makes a good inverter design?

High-efficiency, low THD, and intuitive software make this design attractive for engineers working on an inverter design for UPS and alternative energy applications such as PV inverters, grid storage, and micro grids. The hardware and software available with this reference design accelerate time to market.

How do you operate a DC inverter?

Observe that the current supplied by the DC source at the output decreases, and the inverter supplies the rest of the DC current. As this is DC operation, the inverter operates in buck mode. Increase the DC bus to 380 V. Maintain the closed loop operation as the user raises the DC bus.